Page Comparison

...

5. Add the Vividizer Plug-In to your active DSPs.

   1. go to File->Preferences->Playback->DSP Manager.

   2. In the “Available DSPs” column on the right, click the ‘+’ next to the “VST 2.x/3.x Adapter” to add it to the Active DSPs column. [Note: if “VST 2.x/3.x Adapter” is not an option in your “Available DSPs” step 4 was not completed correctly and must be redone.]

   3. Click the three dots next to the VST 2.x/3.x Adapter in the active DSPs column. A window called “VST Effect Configuration” will open.

   4. Click the drop-down and add the intended version of the Vividizer plug-in. [Note: if no VST effects are found, click “Folders …” and ensure the path to the Vividizer.vst3 is selected. The Vividizer.vst3 should be stored at C:\Program Files\Common Files\VST3. If it still doesn’t show up, the Vividizer plug-in was not installed correctly. Follow the steps in the Vividizer installer again.]

      Image RemovedImage Added

   5. When the Vividizer interface pops up, add your license key or start a trial.

   6. Adjust your Vividizer Half-Span Angle as desired based off of your speaker set-up. Then close the Vividizer interface and the VST Effect Configuration page.

   7. Click “Apply” and then “Ok”.

      Image RemovedImage Added

6. The Vividizer plug-in will now be applied to your audio path. To remove Vividizer, click the “X” to remove it from the “Active DSPs” collumn. To re-add Vividizer to your audio path, click the “+” next to “VST 2.x/3.x Adapter”. It should show up as “VST: Vividizer”. If it doesn’t, re-initialize Vividizer by repeating Step 5.

   Image RemovedImage Added

7. To bring up the Vividizer tuning interface again, simply navigate to File->Preferences->Playback-> Components and under “Active DSPs” click the three dots on the right of “VST:Vividizer“.

...

Tuning Vividizer in Foobar

1. Import the “L” and/or “R” pink noise files above into Foobar.

2. Right click the ‘Play’ button in Foobar and select “Playback Order”.

3. Select “Repeat (track)” in the drop-down. This is how you ‘loop’ audio files in Foobar. Once finished with the tuning procedure, turn this off to prevent audio files from continuing to loop.

...