...
Add the Vividizer Plug-In to your active DSPs.
go to File->Preferences->Playback->DSP Manager.
In the “Available DSPs” column on the right, click the ‘+’ next to the “VST 2.x/3.x Adapter” to add it to the Active DSPs column. [Note: if “VST 2.x/3.x Adapter” is not an option in your “Available DSPs” step 4 was not completed correctly and must be redone.]
Click the three dots next to the VST 2.x/3.x Adapter in the active DSPs column. A window called “VST Effect Configuration” will open.
Click the drop-down and add the Vividizer plug-in. [Note: if no VST effects are found, click “Folders …” and ensure the path to the Vividizer.vst3 is selected. The Vividizer.vst3 should be stored at
C:\Program Files\Common Files\VST3. If it still doesn’t show up, the Vividizer plug-in was not installed correctly. Follow the steps in the Vividizer installer again.]
When the Vividizer interface pops up, add your license key or start a trial.
Adjust your Half-Span Angle as desired based off of your speaker set-up. Then close the Vividizer interface and the VST Effect Configuration page.
Click “Apply” and then “Ok”.
The Vividizer plug-in will now be applied to your audio path. To remove Vividizer, click the “X” to remove it from the “Active DSPs” collumn. To re-add Vividizer to your audio path, click the “+” next to “VST 2.x/3.x Adapter”. It should show up as “VST: Vividizer”. If it doesn’t, re-initialize Vividizer by repeating Step 5.
To bring up the Vividizer tuning interface again, simply navigate to File->Preferences->Playback-> Components and under “Active DSPs” click the three dots on the right of “VST:Vividizer“.
Walkthrough Video
...
Tuning Vividizer in Foobar
...
Import the “L” and/or “R” pink noise files above into Foobar.
Right click the ‘Play’ button in Foobar and select “Playback Order”.
Select In the “Order:” drop down menu, select “Repeat (track)” in the drop-down. This is how you ‘loop’ audio files in Foobar. Once finished with the tuning procedure, turn this off to prevent audio files from continuing to loop.
...
Click play on the pink noise track.
Go to File->Preferences->Playback->DSP Manager, click the three dots next to Vividizer
...
to bring up the Vividizer interface.
...
Adjust the Vividizer Angle to fit your audio setup and then close the Vividizer interface and VST Effect Configuration windows.
Finally, click “Apply” in the ‘DSP Manager’ window to save the changes to your Half-Span Angle.
...
Tuning Recommendations: To tune Vividizer simply change the angle (you don't need to open the tuning window at all) Half-Span Angle until the noise sounds clearly and cleanly outside the speaker, off to your right or left, and preferably up next to your ear, depending on your setup. If one side is more obvious to you, it is recommended to just tune on that side and go with that angle setting.
...